22030 Autoloader 2 ALE2: Plate not detected by the table's plate sensor ThermoFlex Check the sensor - use the 'table' command to poll the sensor. Verify that the plate being used isn't cut with a sharp angle possibly uncovering the sensor. Make sure a plate has been properly registered and attached at the Leading edge. The machine didn't detect a plate on the table when it should have. This check for a plate is done just before rotating the drum to load a plate so there should be plate registered on the drums LE bar. Given the smallest acceptable plate, the sensor should be covered but doesn't seem to be. ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:52 2008 PST